Savant REM-1000 How to connect to wifi

Connect to Wireless Network – SmartConnect

Provisioning using SmartConnect is described below.

1. Power On the Pro Remote Base by plugging the supplied power supply between the Base and a surge

   protected 100V – 240V AC receptacle. Refer to the System Overview section for more information.

2. By default, a new Remote Base is set at the factory to be in Access Point Provisioning Mode (Status LED

   blinking yellow). If it is, skip this step. If not, the bulleted items below describe how to set it into this mode.

• Insert a pointed object (preferably non-metallic) into the reset button pinhole. Press and hold the Reset Button for five seconds until the LED begins a rapid blink (red), then release.

• LED will switch to solid yellow while Base reboots.

• After the reboot (5-10 seconds), the Status LED

  starts blinking yellow once per second indicating it is in Access Point Provisioning Mode and ready to be provisioned with the local network settings.

3. On the iOS device (iPad®, iPhone® etc.), open the SmartConnect Application.  
   https://itunes.apple.com/us/app/savant-smartconnect/id731539621?mt=8

4. Locate the Remote Base in the Devices on Bluetooth section. Copy the Unique ID displayed. The Unique ID (UID) will be used later in the procedure when the REM-1000 system is added to RacePoint Blueprint®.

TIP! To help learn the UID of a specific Remote Base when there is more than one Remote Base entry in SmartConnect, tap the Remote Base entry under the Devices on Bluetooth section. The Status LED on the bottom of the base will blink rapidly (yellow) for 5 to 7 seconds. Locate the Remote Base with the blinking LED and write down the UID displayed.

5. Tap the Remote Base entry from the Devices on Bluetooth dialog window.

6. In the Pick a Network dialog window that opens, tap the Join Other Network... selection (image not shown).

7. In the Other Network dialog window that opens (shown below), enter the following:

   TIP!
   Tap the Use Current Network SSID field to auto populate the Name field with the SSID of the local network.

A SSID of the local network.

8. Tap Join when complete.

9. A Provisioning Success dialog window will open informing the user that the device successfully provisioned to

   the network. Tap OK.

   With the Pro Remote Base provisioned, the LED on the bottom of the Pro Remote Base will blink green indicating it is provisioned to the network but not yet communicating with the Savant Control system host. Refer to the Remote Base Hardware Overview section for LED state information.